iveco 40.10 transfer case information
 

hello all,

new here, yesterday i took a test drive on an iveco 40.10 4wd to my understanding the transfer case modes are as foloowing:
2N= 2 high
4N= 4 high
F= neutral
4R= 4 low

correct?

when engaging 4N while stiationary and trying to drive the truck seemed to be in neutral is that suppose to be?

while engaging 4R while stiationary and trying to drive there was no problem

any input will be welcomed

Hi.

I have a 4010 and it can sometimes be a bit difficult to stop the lever at 4N. Do it slowly and watch on the dash for the light and pull up the lever to lock it into place when you get the light. Thats what i have to do anyway. If it is clearly locking in place and not engaging then you may need to adjust the rod under the cab. Its really easy. Get the manual from the Iveco forum if you need guidance on that

Hope this helps

4wd lever
 

Back to front


2N 2wd normal ratio

4N 4wd normal ratio
F neutral
4R 4wd reduced (low Ratio)


Graeme