KLE wont run over 3000rpm
 

Hi,I have recently bought KLE 500,done 5000km(on clock is now 33000km),everything was fine and then just sudenly bike wont go over 3000(it looks like some electronic issue because i checked carbs and sparks and everything is good),any suggestions will be great THANKS

KLE should run further but..
 

it should go way over 3000 rpm, but if it don't, then it would be wiser not to force because you might grow a bigger poblem instead. especially if something strange is going on either in the clutch.

tired kle
 

I would suspect the carb straight away. Check for freely moving slides, intact diaphagms, clean jets and free breather pipes. Check your air filter.

Don't see any possible involvement of the clutch as suggested by endurin.

An electronic issue would mean that your engine "stutters" as soon as it exceeds 3000 rpm? Or does it just not rev up any higher?

Does the bike run on both cylinders?

Does the bike start normally and easily?

It's almost certainly a fuel flow issue. Check the filter(s). I don't know this bike, but there could be more than one. You should also drop the float bowls just to check that there isn't a main jet lying in the bottom.