![]() |
Oily Boot
XT 600 Tenere 1VJ 1985
My left boot is getting oily on the top of my toe where it meets the gear change lever.:censored: I assume I have got a knackered oil seal, gear change spindle area. Can the seal be changed from the outside or is it an engine out job.:frown: Any help would be appretiated cos I cant make it out from service manual:confused1: Thanks .. Smudge |
Yes
But the tricky part is getting the old seal out without damaging anything else. Pry very carefully with a small screwdriver.
Does not seem the cause, the gear change shaft is behind your toe, and unless you ride backwards, I do not see how oil could end up on your toe. To find location of leak: clean thoroughly. Spray with fine powder (talcum, etc). Ride for 30 minutes. Oil leak will clearly show up. |
There is an oil line that connects onto the bottom of the engine near the gear lever shaft. If the O ring inside the joint is the wrong size or worn it will leak.
I had a similar problem on my Tenere - I couldn't get the correct O ring and tried another which leaked when the engine was revved. |
Have you checked the little screw on the generator cover?
Or the big screw cap that covers the generator nut? Two possibles that are a very easyy fix. hth Pete |
Thanks Gents ... wow... the knowledge on here is spinechilling ... its nice that you are willing to share the knowledge too :thumbup1:
I will give your suggestions a try and report back ... dont wait up though, I am night shift at the mo. not the best time to try anything too technical :frown: |
All times are GMT +1. The time now is 01:07. |