Secondary carb main jet
 

1989 XT600
I need secondary carb main jet. I think its a #130. Seems this was stock for US version non california.
I have a makeshift fix with over torqued jet and would like to fix correctly.
I have found a #120 for XT 350, seems this would fit but could someone please confirm.
Also what drill size would I need to open it up?
If I purchased a jet kit (sigma/dyna) would it come with this jet?
I have looked hard for this and it seems very rare at this point.
Thanks
Greg

after looking at the fiche for the XT350 seems it isn't similar.

All of my sources show that jet is "obsolete". I am picking up 2 XT's tomorrow and may get an extra carb set-up. I may be able to get that jet for you. Depends on the condition of either bike . Both supposedly run but one is apart and I am putting a totally different engine and carb setup in them.

1,30mm drill should equal a 130 stock jet.

does anyone know what other twin carb might use this jet (nipple for fuel line)
I looked at several other fiches and haven't found one.
Also Kedo doesn't ship to US? Mayb if i'm stuck i'll have someone buy then send from Germany

If you watch ebay you may find one, I did...

They are hard to come by, with my 2 parts bike XT's I just bought only one had the carbs and they are the later version so I didn't end up with any extras yet. I have a deal worked out for 2 more '84's and a partial '83 TT , there is supposed to be 2 carb setups, so I may end up with the right ones, but I don't know when I will be picking them up.

Thanks
Since this bike is giving me trouble (other post) I will stick to my makeshift repair as of now since it works.
If i can sort this bike out then I'll have a friend buy from Kedo. Looks like it will cost me about $30 USD for the jet doh
With the little i have run this bike it has just enough potential to keep me going at it but my patience is in view.