Bings, 40mm constant vacuum
Can anyone tell me what the tiny little spring clips at the bottom of the float needles are for? Blowed if I can see. If they get a bit out of position might they be the reason for the floats ocassionally sticking and flooding?
Also, has anybody found the main jet holder to be tight in its seating, I've just taken both of mine out to change the needle jets. They were horrendously tight, and they were both extremely tight to screw out, altogether a harrowing business. I had visions of the thread being wrecked as they came out, but both the bodies and the holders were ok. I did use a bit of localised heat (LPG and a small burner) before they budged. No, I didn't knacker the o-rings.
So, wise ones, how should this job be done, or were mine tighter than other people's?
Thanks,
John
__________________
Johnef
|