Hi All
Just a quick note to allay the fears of all those that think that ECU’s go pear shaped in the Heat, Dust Etc
I have work as a design engineer in the motor industry making robots that take ECU’s out of the curing oven after they have sat in it for approximately 8 hours (depends on the volume of the ECU) between 150 and 180deg C. this is part of the potting and burning in of electrical components process.
While still at MIN of 150Deg C the circuits are fully tested in a high temperature test nest. (Made from PPS 30%)
This was for Delphi (Ford) but is standard practice in the Auto Industry.
So 55deg C ??
Any fears over ECU’s are generally over hyped.
------------------
Rob
Bedford MJ Old, Slow & Orange
__________________
Rob
EX Bedford MJ 
Your Best travelling companions are an Open mind & a Smile :-)
|