Well things didn't work out as planned... The date the new disc would be ready kept getting pushed back, finally the "new" disc was ready - it was my old disc, somewhat straightened and machined - even that wasn't done well, however, the width of the disc varied over 2/10mm. I could have done better with a grinder myself. They couldn't find the metal to make a new disc. Bit frustrating because it is clear that either the guy at the factory or Andrei knew this very early on, but it was never communicated to me even though I had explicitly explained I didn't want to risk using the old disc. In the two weeks I wasted I probably could have received a shipped disc faster.
So not quite sure I'm ready to recommend Andrei at this point. In any event I will have an aftermarket disc Wednesday, the delay hasn't been too bad though as there is an ample supply of  in Ufa and I met some charming Russian girls
|