DRZ 400s seals
HI all 
just a quicky, anyone any thoughts on the rear wheel bearing seals being back to front, as it were, with the spring to the outside ? Took the old ones off like this before bearing change and my clymer is telling me to do this but seems strange as spring is going to last five minutes this way round with the normal crud etc !! Is the actual seal of the seal (as it were), with spring in, going to be to close to the inner edge of the spacer and thats why they do it the other way??
I have got some new stainless spacers which have a raised lip on the inner most edge and when the seals are in with the spring to the inside it all seems hunky-dory to me!!
Any advice cheers
Tim
PS starter relay(before) and output shaft seal(4 miles in) went on one of the bikes yesterday during pre trip shake-down  (sorted seal and hopefully get relay of tinternet, better now rather than later tho as they go thurs!!) so had to swop relays to take each bike out again and thought I'd check the good one, the resistance reading between the switching wires is suppose to be 3.5-5 ohms this was 4.9-5. Is this ok as in spec or better to take a spare as close to limit?
Thanks
|