Did i f*** up my oxford hot grips?
Hello,
I installed oxford hotgrips on my bike over the weekend. The problem is I don't have a garage so half of it was done in the dark,or at least without proper light.
And I crossed the wires ( + to the ground of the bike and vise versa) When I connected the battery again the fuse jumped immediately 
Is it possible I killed the 'heat control unit' by doing this? I checked everything before I installed it so i'm sure it worked before my humungus stupidity.
I checked all the wires to se If none of them are short circuit (there not)
But then i measured out the electrical resistance of the control unit and it measures out 0,... Ohm. Is this correct? It seems odd to me.
I don't know. All I know is I need HELP!!!
Cheers, Pieterjan
|