Get thick heavy duty tubes. Forget that "heat up" bullsh*t. They resist damage better and they're also easier to repair and work with.

Forget slime. It won't stop anything but the TINIEST puncture in a tube and it makes a friggin mess everywhere and makes patches impossible to patch.

I find heavy duty tubes EASIER to change. You can be a *little* rougher with them.

It's all technique. It's not an easy job. Practice practice practice. There are lots of videos on youtube

The best advice I can give you is to get A LOT of HIGH QUALITY patches and at least three tubes of glue (they split and dry up- Dont get stranded). Get some good levers too. A valve key is essential too.

I think these are BRILLIANT. I haven't nicked a tube since I started using them.

Sealey VS1818 Deluxe Tyre Lever 300mm | eBay


I once had 15 punctures in one day whilst in Tanzania. I had a high quality heavy duty tube which was wrecked in a big blow out (nothing to do with the tube). After that I was stuck with cheap tubes and more punctures than I care to remember.

If you haven't got a centre stand on your bike... GET ONE NOW !!

Also, a quality 12v pump will make life easy. I have a 'cyclepump"

http://www.zenoverland.com/tools/cyc...adventure.html

Those crappy £5 pumps are asthmatic and are a bit of a lottery.

Fingers crossed you won't get a single puncture..... You can go months without one and then like me, get 15 in a day.

__________________
Did some trips.
Rode some bikes.
Fix them for a living.
Can't say anymore.