can the cam chain slack produce failures?
Hi, experts guys out there, I have a XT 600 and I rebuilt the upper engine, meaning cylinder, piston, rings, valves seals, seats etc. because of gray smoke. I noticed that the cam chain tensioner was all in (in the last mark) but I did not change it. After all that the bike had a failure at 1/4 throttle (2500 rev). It sputters and shakes as I accelerate more and more, I feel a lot power but a lot of vibration too.
Question: is it possible that the timing is a little bit off due to this slack?
By the way I check the carb, the plug, the gas, the filter and everything was right.
|