Might be making some progress, took the carbs off and stripped them down again and everything seemed OK but noticed when putting them back on that the choke plunger was only coming about half way out and couldn't find any way of getting it to open fully just using the control on the bars, I have checked the 'fingers' for rough bits and put loads of grease on so can't see why it wont run to the end. I currently have a loop of wire twisted round it and hanging out over the oil cooler and it starts a lot better when this is pulled fully out. I think I can live with just pulling the bit of wire but it would be nice to get it working properly if anyone has any suggestions.
__________________
1983 Yamaha XT600 Tenere 34L
|