R80G/S g/box input shaft -clutch centre splines
when checking the clutch plate (100km)i noticed the clutch plate will tilt/rock at the edge approx 3mm .a new clutch plate does the same, this is because there is a slight taper on the g/box input shaft ,max. 0.25mm, towards the g/box end of the shaft .
a R100GS rider has a similar amount of play.
in operation does this matter?
is this "standard" ?
i'm getting my bike ready for a big trip ,do i need to replace the g/box input shaft ?
thanks for any advice
bryan
|