Not sure if this has been mentioned anywhere (first time on the Forum) - The easy KLX FI mod to remove the soft rev limits in the upper gears is as follows:-
1.0 discconnect the clutch switch wire connector (little black plug just under where the clutch cable enters the lever assembly.
2.0 use a short piece of thick wire to short out the 2 outer terminals on the connector block ~ a bit of neat insulating tape work should hold it in place.
3.0 use the tang on the plug upside down to keep it neat ~ i.e so the plug sits upside down below where you pulled it out from.
15secs to un-install - this mod lets you use all the revs in all the gears, most welcome when you go for an overtake and find yourself on the wrong side of the road with your bike slowing.
i did this about 9 months ago no problems have arisen. Note thsi does not actually make any more power appear but does allow you to use whats there.
|