What's best for rear wheel nut removal?
I'm planning my tool kit and am a bit worried about what to take for the rear wheel nut removal (22mm on the Tenere and 24mm on the F650GS twin).
Option 1: I have 22mm and 24mm 12-point sockets intended for a 1/2" drive. I'm probably taking a 3/8" rachet and I have a 3/8"F to 1/2"M adapter, so in theory this should work but I doubt very much if I can get the leverage to loosen or properly tighten the nut.
Option 2: I have 22mm and 24mm 12-point ring spanners but same doubt applies.
Option 3: I looked at sliding T bars on eBay but most are 160mm to 200mm long so again some doubts.
I can hardly rely on finding a length of scafolding pole to act as a breaker bar. What do others pack?
__________________
"For sheer delight there is nothing like altitude; it gives one the thrill of adventure
and enlarges the world in which you live," Irving Mather (1892-1966)
|