What a loads of bollocks!!! :P

Been away from a forum a while and now reading all this makes a big ironic grin into my face

"What a mission!?" You ought to go consult with some mechanic then, to learn how to perform a TB sync correctly? I do my 1100s TB sync less than 5 minutes (try that on any other plastic covered multi cylinders), we can do even a friendly comparision competition who does TB sync faster on a stock bike

Valve clearance check and adjust - I normally do it within 15 minutes, never seen any other bike where it's easier and more intuitive to perform on.

Full service I can do less than an hour if I'm somehow in a hurry. Normally I do it around an hour to 1,5 hours with a in my other hand. On my overengineered fragile jap bike I did it half a day compared to this and understood how much easier it is on a robust "german tank". Suzuki was like a fragile chinese plastic toy where they've been trying to cut down the costs on every corner designing/constructing it, whereas BMWs I own are built to last - more robust construction, thicker and better supported plastic, thicker paint and bits are much better thought through when working on the bike, considerably better accessibility to perform routine tasks, electrics and cabling better supported against the vibrations.

Reliability: together around 100 000kms with my later 1998 R1100GSes have ridden, mostly gravel roads and bumpy tar you only can experience in the ex-USSR countries nowhere else in the World and been bullet proof reliable. Not a single permanent fault per this mileage, only thing that's temporarely failed was the rear brake master cylinder overheating, when the bike was a full day in the sunlight with over +40C weather in Iran, then the rear brake was gone for some time until it cooled down. Also it's done over 17,000+kms of a travel without any maintenance at all on the bike, around half of it in the +45C weather (it's an air-oil cooled bike) in Iran with bad quality very low octane leaded fuel with valves making bad noise under load, that's two up and the bike's being loaded to it's max permitted weight and even over it, rear stock Showa shock kicked into maximum in a bad way often on the potholed smaller roads in Romania, Bulgaria, Turkey and Iran, but nothing gave up on the bike, didn't miss a single beat. I'd easily rate it's reliability to the maximum possible level after experiencing my own what the bike has been through, and I couldn't ask more from it.
Would you try to do the same abuse with a bike where the clutch and gearbox floats in the same engine oil?

I cannot say the same good words for many jap bikes around here, including my Suzuki GSX 600 that's been one of the most unreliable bikes I've ever had with a "massive" 50Kkms I rode it on the bad roads around here until I sold it, paying too much for it's much more expensive service and repair bits. Most of the faults and failures came from electrical side where the japs supposed to be much better and more jap way "hi-tec", but they simply aren't it proved.

I do all the maintenance and work on the bike my own, always.

We all know that every bike will have it's faults sooner or later, I don't consider myself to be very loyal to any make (hell no, I bash BMW service often) but so far my BMWs certanly have proven to me to be one of the most cost effective and reliable bikes to run in the bad conditions we have around here. I simply do not agree with the uncompetent statments above in this thread.

Hendi has made his choice and I think a good one, for 2-up travel the big GS is naturally very well suited.

Happy travels!