I thought "TDI" didn't sound right, didn't remember the words it stood for off hand.
Too much when younger.

I now know that I need a TCI for my bike, but where is the best place to get one? I have checked Ebay but not the correct ones available.

Yamaha XT 600 3TB CDI Zündsteuerung Blackbox Zündeinheit | eBay

Yamaha 3TB 82305 00 00 Centalina CDI XT 600 E TT 600 Ignitor Unit | eBay

Yamaha XT 600 CDI Ignition Igniter Box Unit 3TB 82305 00 131800 5400 563 | eBay

As shown on Partzilla.com

3TB-82305-00-00
IGNITOR UNIT ASSEMBLY
$628.49 $459.09

Very Pricey. I do not know of an aftermarket unit, anyone else?

I do not have a wiring diagram for the newer TCI unit. Perhaps an older type could be retrofitted with some modifications. I know the Zeeltronic is not fussy, give it power and a trigger and it will fire. You might have to change to an older type ignition coil.

Does the newer XT's use stator power or battery power to power up the TCI? Borut make units for other bikes that use battery power to power up his unit, then all you need is a trigger and maybe a matching coil.

Can someone point me to a schematic or send me one?

I found a schematic for an "E" model with electric start. Not sure of year but I suspect they are all about the same as far as the TCI goes. This unit does run on battery on the Red/White wire and is only triggered via the stator on 2 wires so it has a single pickup for triggering. Should be easy to adapt an existing battery powered unit to fire and XT-E model. I am sure the coil would need to be changed out for the older type. Borut has new high out coils if I remember correctly.

I will inquire of Borut at Zeeltronic to see if he can adapt his to work.

Steve

__________________
'84 XT600 is now bored to 2nd oversize and new OEM pistons and rings installed. No more smoking.

After looking over the schematic, it will be very easy for Borut to use an off the shelf model. Single trigger, operates off the bike 12volts. The Zeeltronic has a shift output that could drive the "REV" light directly. Very easy to hook up but would most likely need a replacement coil like the older XT's use.

I have asked Borut about this but have not gotten a reply, it is late in Slovenia so may be tomorrow.

Mezo, do you have a newer Xt using the TCI ignition? Borut will need a tester, I only have the older models and could not test one.

__________________
'84 XT600 is now bored to 2nd oversize and new OEM pistons and rings installed. No more smoking.