Hand Guards for XJ900 Diversion
Hi all,
Has anyone fitted re-enforced or non re-enforced hand guards to a Divvy 900 ? The curve to the bar clamps is quite sharp when compared to a dirt bike and although I haven't bought any guards I am having a hard time visualising the fit. I had some bark busters on a XTZ660 before.
Below are some photos of the bars.
You can see the sharp turns of the bars.
This is the side I can't quite figure out as the master cylinder uses most of the flat space where I thought one end of the guard would go. The hoses might be a problem too.
This side I don't see being a problem
Any ideas ?
Cheers
Last edited by gixxer.rob; 2 Jan 2009 at 00:54.
|